SVC online – Array or not to array: Part 1 – Additional data

At long last I have found some time to post here again. Well actually I don’t have the time but I did it anyway. The thing is – I left a trap in an article I wrote that would force me to make time here – and it worked!   This will be brief – […]

Phase alignment of spectral crossovers

This is a continuation of the impulse response subwoofer thread. Here are some screens from Sounds Systems: Optimaztion and Design that deal with phase alignment of crossovers. The figure above shows the phase responses brought together between sub and main.  The crossover is not steep and therefore the phase response overlap over a wide range. […]

Line Array Gain Taper (Breaking the Line II)

After Bob Gardam’s comment on Breaking the Line I decided to give a quick go of the hypothetical scenario I had proposed in my reply: 12 boxes,  6 @ 2 degrees @ 0 dB, 3 @ 4 degrees @ -2 dB, 3 @ 8 degrees @ -4 dB. I made screen dumps of 3 scenarios: 1) 0,-2, […]

Training at Disney Animation II: Size Matters

In the world of animation the world can be as big a basketball and a basketball can be as big as the world. In the real world, size matters. Not in the animation world. In the world of animation audio, size does not seem to exist either. Low frequencies don’t have a wavelength in ProTools. Sure they […]

Phase Alignment of Subs – Why I don’t use the impulse response

OK. The saga continues down below………………………. What is the best way to phase align our subwoofers to the mains? There is a hint in the way the question was phrased. I didn’t say time align (and it is not because I am afraid of copyright police). I say phase align because that is precisely what […]

Breaking the line

A friend of mine who is not an audio engineer went to a show and later told me it sounded too loud and was unintelligible. Sound plausible? Sure. Now try this: a friend of mine went to a show and said it sounded like the line of the speakers had been broken. Still sound plausible? […]